Aaronhime27
Expert
Been toying with some new molds and really wanted a good effective shorter range sub 300 for a defense or hunting load. I ordered an MP 311-410 hp mold and worked up quite a few loads for it. Below are pics of the 1096fps load. This was range pick up lead melted and poured with no additions. Was water quenched then pc with Ford blue. I'll have to get some water tests next to see expansion in more hydraulic media. This was just shot into soft sand but it's a good indicator I'm on the right track. Accuracy was only tested at 30 yards or so but produced dime size off lead sled. Ran some supers but accuracy with this mix was poor and the bullet seriously disintegrated in sand. Test powder was what I had on hand h110. Will get some aa1680 to see if it will cycle for next test.